Meant to be Seen
https://www.mtbs3d.com/phpbb/

help with my diy hmd
https://www.mtbs3d.com/phpbb/viewtopic.php?f=26&t=22396
Page 1 of 1

Author:  ferslash [ Tue Mar 21, 2017 4:30 pm ]
Post subject:  help with my diy hmd

Guys:

i was gadering information from multiple places so i decided to finally make my own hmd using 5X 5cm lupe lenses and a 7" inch lcd display (1280*800) from aliexpress...

i made some 3d parts and when everythin was completed i got two problems:

1. it only shows a more-less nice image using a lower resolution of 800*600 (using trideff and other software i found, dont remember the name) when i use 1200*800 the image you see has not 3d effect it seams that you are looking two different displays (not a nice binocular effect)

2. the worst, even at a low resolution 800*600 i have an image like this:
Image

insted of:

Image

as you can see, i see the a stripe of the right image at the left of the screen.

i tryed to move horizontally my screen but the stripe is there... what did i make wrong?

please help

best regards

fer

Page 1 of 1 All times are UTC - 6 hours
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/