Page 1 of 1
Lost Planet (DX9 version) (better as farcry)
Posted: Wed May 16, 2007 9:31 am
by scarab
Posted: Wed May 16, 2007 2:52 pm
by Xerion
The graphics are nice yes. But using convergance makes the HUD disappear and it's very buggy when stereo is enabled. (This is on a pc with a 6600GT as well btw, I'm not at the PC from my sig)
Posted: Wed May 16, 2007 3:28 pm
by LukePC1
Hm I'm not shure about the graphics compared to FarCry, but it won't run. Your screens had no Laser sight and I couldn't get it either. At the sides of my monitors appear black bars, which get off, if I use a special mix of convergence and Seperation.
But the most striking point is the performance... it runs very bad on my rig, even with all setting minimized (resolution 800:600). It keeps showing this performance is too low (below 10FPS or so) thing, which interrupts gameplay...
Do you have any Idea to improve 3D performance?
Luke
Posted: Wed May 16, 2007 6:02 pm
by Xerion
The black bars you might be able to get removed by using ctrl+F11 (cycle frustrum adjustment) on newest drivers anyway. (However this function was already in very old drivers according to some PDF, so I suppose only the ability to change hotkey was added in new stereo drivers)
Posted: Wed May 16, 2007 6:12 pm
by Neil
I haven't test this game yet, but usually black bars on the side are a symptom of post processing effects.
Try turning off all items that include: HDR, Bloom, and "Enhanced Lighting".
You can also try reducing "shaders" a notch or two to see if that makes a difference (last resort)!
Neil
Posted: Fri May 18, 2007 2:01 am
by scarab
The game runs very slow at 3d but it also runs slow at 2d.
maybe this is because the game was developed for DX10 but its good that a lot of post processing effects are working (like HDR and Motion Blur).
The game is not released yet and i think it will run better if DX10,SLI and 8xxx drivers are out.