I will try to provide a detailed non bias veiw, as I'm sure you'll likely not want to buy something this expensive without knowing what you'll get.

So far here's what samsung says it can do in regards to 3d.

2d-3d = changes a 2d image to 3d.
side by side = displays two images next to each other
Top & bottom = Displays one image above the another
Line by Line = displays the images for the left and right eye alternately in rows.
Vertical Stripe = Displays the images for the left and right eye alternately in columns
Checker Board = Displays the images for the left and right eye alternately in pixels
Frequency = Displays the images for the left and right eye alternately in frames.

Support resolution (16:9 only)

Resolution | Frequency (Hz)
1280 x 720p | 60 Hz
1920 x 1080i | 60 Hz
1920 x 1080p | 24 / 30 / 60 Hz

Supported formats and operating specifications for
Standard HDMI 3D

Source signal format | Standard HDMI 1.4 3D
1920x1080p@24Hz x 2 | 1920x2205p@24Hz
1280x720p@60Hz x 2 | 1280x1470p@60Hz

I could not figure out how to set to tht following 3D mode.
Top & bottom = Displays one image above the another
Line by Line = displays the images for the left and right eye alternately in rows.
Vertical Stripe = Displays the images for the left and right eye alternately in columns
Checker Board = Displays the images for the left and right eye alternately in pixels
Frequency = Displays the images for the left and right eye alternately in frames.

I have tried many methods, but none of them were successful, anyone has any ideal how to do so?

Thank you.

Do you know what stereoformat the sourcesignal have?

The source signal must be either 720p or 1080p res for any 3D options other than 2D-3D to be available, regardless of source.

Checkerboard, Frame sequential, line interleaved, vertical interleaved are only available with a PC connection (possibly through a specific input only, can't remember)

Left/Right and Above/Below are available through PC connection or with Media Play over network/USB

HDMI only.