Hi guys, since my iz3d inverter board is gone (No backlights). Can it be possible to put the sandwich on top of a overhead projector and get 3d? Its the same stuff behind DIY projectors using an lcd pannel right?

In theory, you could make a DIY projector that used it, but you would need a silverscreen projection surface to preserve the polarization.

And there are no overhead projectors large enough for a 22" panel. If you want to make a DIY projector, head over to the LumenLabs forums, they can help you a lot. But there is no easy way to do this, most people avoid larger panels and use smaller, easier to build around panels.

Thanks PalmerTech,

My iz3d is actually a 17" one so maybe I can get it to work by using just a silver screen as suggested. Thanks!

Oh, you are that guy! Yes, you may be able to find one that fits. Although to be honest, a silverscreen of any size is going to cost you several hundred dollars...

Ouch! Lets see if I can find a cheaper solution. Thanks!

Nah! Any "decor" spraypaint will do.